Mesto PERLA PLUS 3265P Mode D'emploi page 13

GB IRL
Avoid ignition sources in the environment if you spray combustible liquids.
Do not allow the device to remain under pressure and/or exposed directly to
sunlight. Make certain the device is not heated beyond the maximum operating
temperature (→ Table 1). Protect the device from frost.
Never blow through the nozzles or valves with your mouth.
Use only MESTO spare and accessory parts.
We cannot assume any liability resulting from the use of third-party parts.
Wear suitable protective equipment when working with hazardous substances.
When pumping, always observe the piston pressure gauge to ensure the maximum
spraying pressure is not exceeded (→ Table 1 below).
Before filling, after use and before maintenance work, allow the residual pressure in
the tank to dissipate completely (→ Section "After Use", Section 1).
S c ope of delivery
Tank [1] with pump [2], hose [3], instructions for use [4], lever set (only for CLEANER) [5],
shut-off valve [6], carrying strap [7], spray lance with flat jet nozzle [8], extension tube [9]
(Fig. 1).
You will find the illustrations referred to above in the front fold-out pages (pages 3 – 5).
T ec hnic al data
Device group
Type of device
Max. filling amount
Total content
Max. spraying pressure
Max. operating temperature
Weight when empty
Material of tank
Where device is carried
Technical residual quantity
Max. volume flow
Recoil force
Pressure change from 0 to 3 bar
Table 1
AUS USA
P E R L A P L US
3265P
5 l
7.5 l
1.8 kg
Polyethylene
13
NZ CDN
C L E ANE R
3268P 3265P P
8 l 5 l
10.5 l 7.5 l
3 bar
30 °C
2.4 kg 1.8 kg
Polyethylene
on the side
< 0.07 l
0.78 l/min
< 5 N
min. 5000 x
IND
3268P P
8 l
10.5 l
2.4 kg