Amanngirrbach Giroform Mode D'emploi page 16

GB
SAWING OF THE MODEL
Reposition the trimmed dental
arch on the plinth plate without
applying pressure. Between the
dental arch and the plinth plate
a gap of approx. 2 mm is visible
resulting from the plaster expan-
sion. The advantage is that you
see the pins when sawing.
Fix the plinth plate in the model
table of the DIACUT model saw
(171800). Align the model table in
accordance with the cutting di-
rection. The saw cuts as defined.
16
The linear expansion stress resol-
ves; the segment drops onto the
plate and rests tightly.
Tip: Cut the dental arch in halves
first and remove one half so you
can effect the saw cuts with less
hindrance. Thus, the opposing si-
de of the dental arch is protected
form getting harmed.
Clean all segments and reposition
them tightly on the cleaned plinth
plate.