Fuse (Combi D 6 E); Overheating Protection (Combi D 6 E); Technical Data; Dimensions - Truma INet Ready Combi D 6 Mode D'emploi

Chauffage au gazole
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
230 V fuse (Combi D 6 E)
The fuse and the power supply lines must only be replaced by
an expert!
The unit must be disconnected from the mains (all
poles) before opening the electronic housing lid.
The fuse is in the power electronics (14) beneath the elec-
tronic housing lid.
This fine fuse must always be replaced with a fuse of the
same type: 10 A, slow-acting, interrupting capacity "H".
Figure 5
230 V overheating protection (Combi D 6 E)
The 230 V heating facility has a mechanical overheating
switch. If the 12 V power supply is interrupted during opera-
tion or during the after-run period, for example, the tempera-
tures within the unit could activate the overheating protection.
Figure 6
To reset the overheating protection, allow heater to cool, re-
move connection cover and press red reset button.
Determined in accordance with Truma test conditions
Fuel
Diesel as per EN 590
Water capacity
10 litres
Heating time from approx. 15 °C to approx. 60 °C
Boiler approx. 20 minutes (measured according to EN 15033)
Heater + boiler approx. 80 min.
Pump pressure
max. 2.8 bar
System pressure
max. 4.5 bar
Rated thermal output (automatic operating level)
Diesel mode
2000 W / 4000 W / 6000 W
14
Electric mode
900 W / 1800 W
Mixed mode (diesel and electric)
max. 5800 W
Fuel consumption
220 – 630 ml/h (110 ml/h with average heat output of 1000 W)
Air delivery volume (free-blowing without warm air duct)
With 4 warm air outlets max. 287 m³/h
T 10 A
Power consumption at 12 V
Heater + boiler 1.8 – 4 A (in control mode between "Off"
and "Lowest operating level" less than 1.8 A)
Heat up boiler without heating operation max. 1.8 A
Stand-by approx. 0.001 A
Heating element – FrostControl (optional): maximum 0.4 A
Power consumption at 230 V
3.9 A (900 W) or 7.8 A (1800 W)
Weight (without water)
Heater:
Heater with
peripheral devices: 17.2 kg 18.3 kg (Combi D 6 E)
Subject to technical changes.

Dimensions

Figure 7

Technical data

15.8 kg 16.9 kg (Combi D 6 E)
450 mm
525 mm
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Inet ready combi d 6 eCombi d 6 eCombi d 6

Table des Matières