Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8549776
AIR TOOL PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults before each
use. Discontinue use if the air hose is damaged or hissing is heard from
the air hose or connectors, while operating the tool. Replace the defective
component/air hose.
2.
Do not allow people, mobile equipment or vehicles to pass over the
unprotected air hose. Position the air hose away from high traffic areas, in
a reinforced conduit or place planks on both sides of the air hose to create
a protective trench.
3.
Prevent damage to the air hose by observing the following:
a.
Never carry the tool by the air hose.
b.
Keep the air hose behind the tool and out of the tool's work path.
c.
Keep the air hose away from heat, oil, sharp edges or moving parts.
d.
Do not wrap the air hose around the tool as sharp edges may pierce
or crack the air hose. Coil the air hose when storing.
4.
A damaged or disconnected air hose under pressure may whip around and
inflict personal injury or damage the work area. Secure the compressor's
air hose to a fixed or permanent structure with clamps or cable ties.
5.
Install an in-line shutoff valve or regulator to allow immediate control over
the air supply in an emergency, even if a hose is ruptured.
6.
Check the manufacturer's maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated so as to never
exceed the maximum pressure rating of the tool.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
6
1/4 in. Air Hydraulic Riveter
For technical questions call 1-800-665-8685
V 4.1
Publicité
Table des Matières
