Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.1
CARE & MAINTENANCE
1.
Make sure the trigger switch is in the OFF position and the air source is removed
from the tool before performing any inspection, maintenance or cleaning.
2.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
3.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
4.
Daily maintenance: Use a soft, dry cloth to remove all dirt, grease and
debris from the exterior of the tool. Do not use solvents to clean the tool.
IMPORTANT! Do not immerse the tool in liquids.
5.
Follow instructions for lubricating and changing accessories.
6.
Only use accessories intended for use with this tool.
7.
Keep the tool handles clean, dry and free from oil/grease at all times.
8.
Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
ADDING HYDRAULIC OIL
1.
Use the hexagonal column (#53) and wrench (#51) to unscrew the cylinder
cap (#46) from the bottom of the air cylinder (#22). See Figure 1.
2.
Remove the piston assembly (#41 to 46) from
the air cylinder (#22) by using pliers (sold
separately) to pull out the piston by grasping the
air piston lock nut and pulling the assembly out.
3.
Hold the air cylinder (#22) upside-down and
pour hydraulic oil (sold separately) into the
reservoir and fill to just below the bottom of the
lock nut (#39). See Figure 2.
IMPORTANT! Do not overfill.
Visit www.princessauto.com for more information
1/4 in. Air Hydraulic Riveter
8549776
Fig. 1
9
Publicité
Table des Matières
