Troubleshooting - Dometic ROLLERBLIND POWERED Instructions De Montage Et De Service

Rollerblind Powered
I
NOTE Cleaning by professional cleaning personnel
The manufacturer cannot be held liable for improper cleaning methods
or agents used by professional cleaning personnel. In this case, the
responsibility lies with the cleaning company.
Removing dust
➤ Dust the blind regularly with a dust rag, dust glove or a vacuum cleaner with a
brush attachment. Blow excess dust off of your fabric using a can of compressed
air or a hair dryer on a cool setting.
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around side tracks or guide wires.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild deter-
gent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Cleaning windows
➤ Always ensure the blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
10

Troubleshooting

Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
EN
Solution
➤ See chapter "Fitting the guide wire ver-
sions" on page 10.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
Troubleshooting
13