Operation; Cleaning And Maintenance - Dometic ROLLERBLIND POWERED Instructions De Montage Et De Service

Operation

➤ Refer to the AP Remote control manual for further instructions.
8 Operation
!
CAUTION! Risk of injury
Only for boats and yachts: If the blind is in front of an open window,
then the blind should be stowed when driving at more than 10 knots or
in a sea state of more than moderate, as this can cause damage to the
blind. Parts that come loose may injure persons in the vicinity.
I
NOTE
The motors have thermal cut-out devices built-in in order to prevent the
motors over-heating for safety reasons. Prolonged, repeated use or
overloading the blind could trigger the cut-out. If this happens allow the
motor to cool for a few minutes.
Observe the following notes:
• Each blind can be stopped in any position.
• When operating the blind with an automation system, operation depends on the
programming of the controls.
• The blind is set up in the factory to automatically stop:
– When the blind is fully deployed
– When the blind is fully stowed
9

Cleaning and maintenance

A
NOTICE! Risk of damage
• Do not grease, oil or lubricate the blind. Lubricants will damage the
fabric.
• Be careful not to crease the fabric when using the brush attachment
of a vacuum cleaner.
• Rubbing can damage the fabrics.
• Spot-cleaning may result in cleaner areas than the surrounding.
• Do not soak the blinds.
• The manufacturer recommends testing any cleaning agents on a
hidden area of the blind first.
12
Rollerblind Powered
EN