27 7.3 Changing The Battery Of The Purion Display; Storing The E-Bike Battery - Urban Arrow Tender 1000 Manuel De L'utilisateur

After charging
The procedure after the charging procedure is terminated is as
follows:
1. Disconnect the charger from the main power supply.
2. Disconnect the battery from the charger. The battery
automatically switches off.
3. If you have charged the battery while placed in the battery
holder on the bike, carefully close the charge socket with the
cover so no dirt or water can get into the charge socket.
2
Once the battery is charged it will switch off. If the charger
is not disconnected from the battery after charging, after
a few hours the charger will switch itself back on, check
the charging state of the battery and begin the charging
procedure again if necessary.
7.3 Changing the battery of the Purion display
The Purion display is supplied with voltage by two CR 2016 button
cells. When the display shows the text ' low bat ' the two batteries
need to be replaced. Changing the batteries is done as follows:
1. Unscrew the fastening screw 81 of the display.
2. Remove the display from the handlebar 76 .
3. Open the battery compartment cover 80 by using a coin and
turning it counter clockwise (see image 30).
4. Remove the used battery and insert two new CR 2016
batteries.
2
Mind that the polarity of the battery is correct when inserting
the new battery.
User manual
5. Close the battery compartment cover by using a coin and
turning it clockwise.
6. Place the display back on the handlebar and fasten it with the
fastening screw.
Image 30: Changing the batteries of the Purion display
7.4

Storing the e-bike battery

If you plan to park your bike for a longer period we advise you to do
the following:
● Charge the e-bike battery to approximately 60 % (3 to 4 LEDs
lit on the charge-control indicator 44 ).
● Take out the e-bike battery and take off the Intuvia display.
Store them in a dry and safe place.
EN
43