Urban Arrow Tender 1000 Manuel De L'utilisateur page 44

Image 28: Plugging charger plug in charge socket on the bottom part
of the battery holder
Charging the e-bike battery after it has been removed from the
e-bike is done as follows:
1. Place down the battery on a clean surface. In particular, avoid
soiling the charge socket and the contacts, e.g. by means of
sand or soil.
2. Press the on/off button 46 to switch off the battery.
3. Remove the battery from the holder (see paragraph 5.6).
4. Insert the charger plug 22 of the battery charger into the
socket (see image 29) on the battery.
5. Connect the mains cable of the battery charger to the mains
supply. The charging procedure will start.
See below for more information on the charging status
Tip
and what to do after charging.
42 Urban Arrow Tender
Image 29: Plugging charger plug in charge socket on the battery
Charging state of the e-bike battery
The e-bike battery can be charged with or without the display.
When charging without the display, the charging procedure can be
observed on the battery charge-control indicator 44 . When charging
with the display the bars on the display show the progress as well.
2
The Intuvia display can be removed during the charging
procedure or fi tted after the charging procedure has started.
Each continuously lit LED on the charge-control indicator 44 is
equivalent to a charge capacity of approx. 20 %. A fl ashing LED
indicates the charging of the next 20 %. Once the e-bike battery
is fully charged, the LEDs extinguish immediately and the display
(in case mounted) is switched off. The charging procedure is
terminated.