Placing And Removing The E-Bike Battery From The Battery Cradle - Urban Arrow Tender 1000 Manuel De L'utilisateur

2
If the internal battery is weak when the display is switched
on, 'Attach to bike' will appear in text indication 68 for 3 s.
The display will then turn off again.
Charging the internal battery of the Intuvia display is done as
follows:
1. Insert the e-bike battery 47 in the battery cradle (see
paragraph 5.6.2).
2. Put the display in the holder 33.
3. Press the on/off button 70 of the e-bike battery to switch on
the e-bike battery. The internal battery of the display will be
charged now.
You can also charge the display via the USB port 61 (see
Tip
paragraph 5.9).
5.6.2 Placing and removing the e-bike battery from the battery
cradle
Inserting the e-bike battery is done as follows:
1. Press the on/off button 70 of the e-bike battery to switch off
the e-bike battery 47.
1
Sparks may be generated between the terminals of your
battery and ones of the holder when you don't switch off the
battery. These sparks may lead to injuries.
2. Check if the upper and lower battery holder 52 and 43 are
clean (no dirt or debris).
3. Place the key into the battery lock 13.
User manual
2
The battery lock uses the same key as the ring lock 42.
4. Unlock the battery lock by turning the key counter clockwise.
5. Place the battery with the contacts on the lower holder on the
e-bike (see image 17).
6. Tilt the battery into the top part of the battery holder until it
engages. The battery is now locked. See image 18 and 19 for a
correctly and incorrectly fitted battery.
2
You will hear a click when the battery is inserted correctly.
7. Check if the battery is tightly seated. There should be very
little play.
8. Remove the key from the battery lock.
2
Removing the key prevent the e-bike battery from being
removed by unauthorised persons when the e-bike is parked.
EN
29