Pb (Lead-Sulphuric Acid) Battery Program; Charging Pb Batteries; Discharging Pb Batteries - ANSMANN Racing xMove 2.0 Deluxe Mode D'emploi

17. Pb (lead-sulphuric acid) Battery
Program
This is programmed for charging Pb (lead-acid) batteries with a
nominal voltage from 2 to 36 V. Pb batteries are totally different
from NiCd or NiMH batteries. They can only deliver relatively lower
current compared to their capacity, and similar restrictions definitely
apply to charge. So the optimal charge current will be 1/10 of the
capacity. Pb batteries must not be charged rapidly. Always follow the
instruction supplied by the manufacturer of battery.

18. Charging Pb Batteries

Battery Elapsed
type time
Charge
current

19. Discharging Pb Batteries

Battery Elapsed
type time
Discharge
current
Balance Charger xMove 2.0 Deluxe
Charged Battery
capacity voltage
Discharged Battery
capacity voltage
When you are willing to alter the parameter value in the program,
press "Start/Enter" key to make it blink, then change the value with
INC ► or ◄ DEC key.
The value will be stored by pressing "Start/Enter" key once.
Set up the charge current on the left and the nominal voltage of the
battery on the right. The charge current ranges from 0.1 to 7.0 A and
the voltage should be matched with the battery being charged.
Start the charge process by pressing "Start/Enter" key for more than
3 seconds.
The screen displays shows the state of charging process. To stop
charging forcibly, press "Batt type/Stop" key once.
The audible sound indicates you the end of process.
Set the discharge current on the left and the final voltage on the
right. The discharge current ranges from 0.1 to 5.0 A.
To start the process, press "Start/Enter" key for more than 3 seconds.
The screen displays the current state of discharge. You can alter the
discharge current by pressing "Start/Enter" key during the process.
Once you change the current value, store it by pressing "Start/Enter"
button again.
To stop discharging press "Batt type/Stop" key once. The audible
sound indicates you the end of process.
15