Storage' Control Lithium Battery; Discharging Lithium Batteries - ANSMANN Racing xMove 2.0 Deluxe Mode D'emploi

11. 'STORAGE' Control Lithium Battery

This is for charging or discharging Lithium battery not to be used for
the time being. The program will determine to charge or discharge
the battery to the certain voltage depending on the voltage of the
battery at its initial stage.
Number Elapsed
of cells time
Charge or
discharge
current

12. Discharging Lithium Batteries

Number Elapsed
of cells time
Discharge
current
12
Supplied Current
capacity voltage of
battery
Discharged Battery
capacity voltage
They are different from the type of the battery, 3.75 V for Lilo,
3.85 V for LiPo and 3.3 V for LiFe per cell. If the voltage of the
battery at its initial stage is over the voltage level to storage, the
program will start to discharge.
You can set up the current and the voltage of the battery pack to be
charged. The current will be used for charge or discharge the battery
to reach the 'storage' level of voltage.
The screen shows the present situation during charge process. To stop
charging press "Batt type/Stop" key once.
The value of discharge current on the left side of the screen may not
exceed 1C for a maximum safety and the final voltage on the right
should not be under the voltage level that is recommended by the
battery manufacturer to avoid deep discharging.
To start to discharge press "Start/Enter" key for more than 3 seconds.
(Discharge current: 0.1∼5.0 A)
This shows the present state of discharge. To stop discharging press
"Batt type/Stop" key once.
Instruction Manual