Balance Socket Connection Diagram; Nimh, Nicd Battery Program; Pb Battery Program - ANSMANN Racing xBase 2.0 SE Mode D'emploi

8. Balance Socket Connection Diagram

9. NiMH, NiCd Battery Program

10. PB Battery Program

This is programmed for charging Pb batteries with a nominal
voltage from 2 to 20 V. Pb batteries cannot be charged rapidly. They
can only deliver relatively lower current compared to their capacity.
Intelligent Digital Balance Charger xBase 2.0 SE
Top view
When you are willing to alter the parameter value in the program,
press the "Enter" key to make it blink, then change the value
with the "INC/DEC" keys. The value will be stored by pressing the
"Enter" key once. Then press the "Enter" key for more than
2 seconds to start the process.
This shows the present situation during charge process.
To stop the charging press the "Mode/Esc" key once.
The optimal charge current will be 1 /10 of the capacity. Please
always follow the instruction supplied by the manufacturer of the
battery.
When you are willing to alter the parameter value in the program,
press „Enter" key to make it blink, then change the value with the
"INC/DEC" keys. The value will be stored by pressing the "Enter"
key once. Then press the "Enter" key for more than 2 seconds to
start the process.
This shows the number of cells you set up and the processor
detects. "R" shows the number of cells found by the charger and
„S" is the number of cells selected by you at the previous menu. If
both numbers are identical you can start charging by pressing the
"Start/Enter" button. If the numbers are not identical, press the
"Mode/Esc" button to go back to the previous menu. Then carefully
check the number of cells of the battery pack to charge again.
This shows the present situation during charge process.
To stop the charging press the "Mode/Esc" key once.
Individual
balance
port
5