Lithium Battery (Lilo/Lipo/Life) Program; Charging Lithium Battery - ANSMANN Racing xMove 2.0 Deluxe Mode D'emploi

6. Lithium Battery (Lilo/LiPo/LiFe) Program

These programs are only suitable for charging and discharging
Lithium batteries with a nominal voltage of 3.3 V, 3.6 V and 3.7 V
per cell. These batteries need to adopt a different charge technique is
termed a constant voltage (CV) and constant current (CC) method.
The charge current varies according to the battery capacity and
performance. The final voltage of charge process is also very
important; it should be precisely matched with the charade voltage of
the battery. They are 4.2 V for LiPo, 4.1 V for Lilo, and 3.6 V for LiFe.

7. Charging Lithium Battery

Number Charging
of cells time
Charge
current
Balance Charger xMove 2.0 Deluxe
Battery Charged
voltage capacity
The charge current and nominal voltage as for cell count set on the
charge program must always be correct for the battery to be charged.
When you are willing to alter the parameter value in the program,
press "Start/Enter" key to make it blink then change the value with
INC ► or ◄ DEC key. The value will be stored by pressing the
"Start/Enter" key once.
The left side of the first line shows the type of battery you select
at the users setting. The value on the left side of second line sets a
charge current and the value on the right side of second line sets the
voltage of the battery pack.
After setting the current and voltage press "Start/Enter" key for more
than 3 seconds to start the process.
(Charge current: 0.1∼7.0 A, Voltage: 1∼8 series)
This shows the number of cells you set up and the processor detects.
'R:' shows the number of cells found by the charger and
'S:' is the number of cells selected by you at the previous screen.
If both numbers are identical you can start charging by press
"Start/Enter" button. If not, press "Batt type/Stop" button to go back
to the previous screen. Then carefully check the number of cells of the
battery pack to charge again.
The screen shows the present situation during charge process. To stop
charging press "Batt type/Stop" key once.
9