Emission Control System Information; Replacement Parts - Power Fist 8700718 Mode D'emploi

V4.1
CLEANING FUEL TANK FILTER
IMPORTANT! Read the Engine Refueling Precautions
before cleaning the fuel tank filter.
1. Remove the fuel cap and filter.
2. Clean the filter with gasoline.
3. Wipe the filter with a clean rag.
4. Reinstall filter and fuel cap.

EMISSION CONTROL SYSTEM INFORMATION

The combustion process produces carbon monoxide, hydrocarbons, and oxides of
nitrogen. Control of these emissions is very important for personal and
environmental health.
The following instructions must be followed in order to keep the emissions from
your engine within Canadian emission standards.
1. Do not remove or alter any part of the intake, fuel, or exhaust systems.
2. Do not alter or bypass the governor linkage or speed-adjusting mechanism to
cause the engine to operate outside its design specifications.
PROBLEMS THAT MAY AFFECT EMISSIONS
If you are aware of any of the following symptoms, have your engine inspected and
repaired by a qualified technician.
1. Hard starting or stalling after starting.
2. Rough idle.
3. Misfiring or backfiring under load.
4. Afterburning (backfiring)
5. Black exhaust smoke or high fuel consumption

REPLACEMENT PARTS

The emission control systems on your engine were designed, built, and certified
to conform to Canadian emission regulations. The use of genuine parts is
recommended whenever maintenance is done to the engine. Genuine
replacement parts are manufactured to the same standards as the original parts.
Using replacement parts that are not of the original design and quality may
impair the effectiveness of your emission control system.
Visit www.princessauto.com for more information
2,000W Inverter Generator 8700718
Fig. 17
23