Engine Oil - Power Fist 8700718 Mode D'emploi

V4.1
7. Fill the tank to approximately 1.5 in. (38 mm) below the top of the fuel tank
to allow for fuel expansion. Take care to not overfill the tank. It may be
necessary to lower the fuel level depending on operating conditions.
8. Reinsert the fuel tank cap and tighten.
9. Wipe up any spilled fuel before starting the engine or allow to evaporate.
Spilled fuel is both a fire hazard and an environmental hazard. Dispose of
the fuel soaked rags in a proper hazardous waste container.
HOW TO DRAIN FUEL
1. Turn the 3-in-1 switch to the OFF position.
2. Remove fuel cap and fuel tank filter.
3. Use a siphon to transfer gasoline from generator into a gasoline approved
container.
4. Wipe up any spilled fuel with a clean rag.
5. Start generator engine and let it run until it stops and all remaining fuel
is consumed. Do not connect electronic devices to the generator during
this process.
6. Turn the 3-in-1 switch to OFF.
7. When the engine has completely
cooled down, turn the Fuel Cap Air
Vent to the OFF position.
8. Remove the outer casing screws, then
remove outer casing.
9. Drain fuel from the carburetor by
loosening the drain screw on the
carburetor float chamber.
10. Tighten the drain screw.
11. Install the outer casing and tighten screws.

ENGINE OIL

NOTICE! Engine oil is a major factor affecting engine performance and
service life. Non-detergent and 2-stroke engine oils will damage a 4-stroke
engine and are not recommended.
Visit www.princessauto.com for more information
2,000W Inverter Generator 8700718
Fig. 8
17