Check The Engine; Starting The Generator; Recoil Start - Power Fist 8700718 Mode D'emploi

V4.1
3. Look for signs of damage.
4. Check that all shields and covers are in place.
5. Check that all nuts, bolts and screws are tight.

CHECK THE ENGINE

1. Check the fuel level.
2. Check the engine oil level. Running the engine with a low oil level can
cause engine damage (see Engine Oil section).
3. Check the air filter element. A dirty air filter will reduce engine performance
(see Service the Air Filter).
GROUND THE GENERATOR
The generator must be properly grounded to prevent
electric shocks. Connect the generator to a ground
rod with an 8 AWG copper wire. Twist the wire onto
the generator's ground connector between the lock
washer and nut and secure the nut. Consult municipal
electrical codes or a qualified electrician to confirm
grounding requirements.

STARTING THE GENERATOR

Do not crank engine with spark plug removed. Ensure spark plug lead is
securely connected to spark plug, otherwise unintentional sparking can result,
causing fire or electric shock.

RECOIL START

WARNING! Failure to follow the steps below will result in rapid retraction of
the starter cord faster than the user can let go. This will pull the user's
hand and arm toward the engine, possibly resulting in serious injury.
1. Remove all the loads from AC and DC power outlets.
2. Turn the Eco Switch (R) to OFF.
a. The ECO switch may be left on, but allow three minutes for the engine
to warm up before use if the ambient temperature is below 32ºF (0ºC).
It will be ready for normal operation after warming up.
3. Rotate the gas cap air vent (F) to the ON position (Fig. 6).
Visit www.princessauto.com for more information
2,000W Inverter Generator 8700718
Fig. 5
11