Power Fist 8700718 Mode D'emploi page 19

V4.1
4. Clean the oil fill area of any dirt and debris to
prevent contamination that can damage the engine.
5. The engine has a dipstick that is either part of the
oil fill plug (Fig. 11) or a separate component.
a. Remove the dipstick and wipe with a
clean cloth.
b. Reinsert the dipstick into the filler neck until
it rests on the opening's rim. Do not screw
the oil fill plug back into the opening.
c. Remove the dipstick and check that the oil is
between the Full and Fill marks. Add or drain
oil based on the measurement.
d. Reinsert the dipstick and either press firmly
to hold in place or screw the oil fill cap
hand tight.
6. Replace the side panel and secure with screws.
Replace the spark plug cover.
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to ensure that it
is suitable for the engine.
1. Follow steps 1 to 4 in HOW TO CHECK OIL.
2. Remove the oil filler cap and place to one side.
3. Place a funnel into the oil fill neck. The funnel opening should be wide
enough to prevent the oil from collecting in the funnel's cone.
4. Pour oil into the funnel. Allow the oil to settle for one minute and recheck
the level. Repeat until the oil reaches the outer edge of the oil fill hole.
5. Insert and hand tighten the oil filler cap.
6. Wipe up any spilled oil. Dispose of oil soaked rags in a proper hazardous
waste container.
7. Replace the side panel and secure with screws. Replace spark plug cover
Visit www.princessauto.com for more information
2,000W Inverter Generator 8700718
Fig. 10
Fig. 11
19