Pre-Operation Checks - Power Fist 8700718 Mode D'emploi

8700718
PARALLEL OUTLETS (T)
The parallel outlets allow two 2,000W Inverter Generators to be run together to
increase the rated output to 3.0 kV-A, and the rated current to 25A/120V. This
requires a parallel cable kit (sold separately).
GROUND TERMINAL (P)
Grounding the generator protects you from electric shock that results from a
build-up of static electricity or undetected ground faults.
DC AND AC CIRCUIT BREAKERS (N & O)
The circuit breakers automatically turn OFF when the wattage of connected electronic
devices exceeds the generator's rated output. Reduce the load of connected electronic
devices until the load is within the rated output. To re-establish DC power, push the
DC 8A button (N). To reestablish AC power, push the AC 15A button (O).
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.

PRE-OPERATION CHECKS

WARNING! Do not start or run the generator in an enclosed area, even if
doors or windows are open. Engine exhaust contains carbon monoxide, an
odourless and colourless poison gas.
NOTICE! The generator is not shipped with oil. Before starting the engine,
add oil according to the instructions in this manual. Starting the engine
without oil will damage the engine beyond repair.
Check the generator's condition before operating to maximize the user's safety
and the service life of the generator. Ensure that the generator is level and the
engine switch is in the OFF position before beginning the pre-operation checks.
GENERAL CONDITION
1. Look around and underneath the generator for signs of oil or gasoline leaks.
2. Remove any excessive dirt or debris, especially around the spark arrestor
(B) and recoil starter (H).
10
2,000W Inverter Generator
For technical questions call 1-800-665-8685
V4.1