Care & Maintenance; Fuel Recommendations - Power Fist 8700718 Mode D'emploi

V4.1
CHARGING A 12 VOLT BATTERY
The 2,000W Inverter Generator can recharge a 12V car battery with a set of
special cables that plug into the DC outlet (sold separately).
1. Clean corrosion from the battery terminals with a wire brush.
2. Start the generator and turn the 3-in-1 start switch to the RUN position.
Ensure the DC circuit breaker (N) is also set.
3. Securely connect the red cable clamp to the positive (+) battery terminal.
4. Securely connect the black cable clamp to the negative (-) battery terminal.
5. Turn the ECO switch to the OFF position to start charging the battery.
6. The battery is considered fully charged when the gravity of its fluid is
between 1.26 and 2.28 when measured by a hydrometer.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this tool.
4. Keep the tool handles clean, dry and free from oil/grease at all times.
5. Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
6. Disconnect the spark plug lead and keep it away from the spark plug
during maintenance and repairs.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

FUEL RECOMMENDATIONS

NOTICE! Do not use unapproved gasoline, such as E85. Do not mix oil in
gasoline or modify the engine to run on alternate fuels. This can damage the
engine components. To protect the fuel system from gum formation, mix a
fuel stabilizer into the fuel.
Visit www.princessauto.com for more information
2,000W Inverter Generator 8700718
15