Cleaning The Dust Filter; After Cleaning; Emptying Waste Container; Turn Off Device - Kärcher B 300 RI LPG Mode D'emploi

6.3.1.1

Cleaning the dust filter

Dedust the dust filter daily. Several times a day as well
when working in extremely contaminated areas.
ATTENTION
Risk of damage!
6.3.2 Stopping sweeping
Stop the machine.

Switch off the brushes.

Note
The brushes lift up.
The side-brushes lift up.

Switch off suction blower.

6.3.3

Emptying waste container

DANGER
Risk of injury!

During the entire emptying process, make sure that no
persons or animals are located nearby (waste contain-
er swivels out).
DANGER
Risk of crushing!

Never reach into the rod assembly for the drainage
mechanism. Do not stay under the raised container.
DANGER
Danger of tipping!

Place the device on an even surface during the empty-
ing process.
DANGER
6.4

Turn off device

Park the machine on an even surface.

Park the machine in a safe and dry place.

Turn ignition key to "0" and remove it.

Note
With LPG devices, a switch-off delay lasting a few sec-
onds may occur.
Activate parking brake.

For additional information on shutting down the device,

see the Chapter "Storage/decommissioning".
20

Never set the filter dedusting switch to continuous op-
eration.
Switch off the suction blower before dedusting.

For dedusting, press the filter dedusting switch 4 - 5

times for approx. 5 seconds (no continuous operation!).
6.3.2.1

After cleaning

Dedust the dust filter with the filter dedusting switch

(see Chapter "Cleaning | Dedusting the dust filter".
Empty waste container.

(see Chapter "Sweeping | Emptying the waste contain-
er")
Clean the device and the waste container daily after

work.
(see Chapter "Cleaning").
Danger of tipping!

Do not drive long distances with the waste container
raised, drive slowly!
NOTICE
The container can only be tilted and emptied once a set
minimum level has been reached.
The high emptying system of the appliance allows the di-
rect disposal of the waste in the waste container into a re-
fuse container (for maximum unloading height see Chapter
"Technical data").
1 Waste container
2 Flap of waste container
3 Safety support
Use only with cleaning and maintenance work
4 Raising/lowering high emptying of waste container
5 Open/close flap of the waste container
During the entire emptying process, make sure that no

persons or animals are located nearby (waste contain-
er swivels out).
Position the device approximately in front of the collec-

tion container.
Close the waste container flap (display lamp must be il-

luminated).
Actuate the lever and raise the waste container.

With the waste container raised, move slowly over the

collection container.
Open the flap and empty the waste container.

ATTENTION
Remain seated calmly during the entire emptying proce-
dure (do not stand up from the driver seat), otherwise there
is a danger of the seat contact switch switching off during
the emptying procedure.
19
-
EN