Sweeping Mode - Kärcher B 300 RI LPG Mode D'emploi

6.2.7 Emptying the Fresh Water Tank
6.3 Sweep
CAUTION
Risk of damage!

Do not sweep up packing strips, wire or similar objects
as this may choke up the suction canal.

Do not operate the brushes on the spot.
6.3.1

Sweeping mode

The waste water tank drain hose is located on the right-
hand side of the device.
1 Closing head
2 Bracket
3 Dosing equipment
4 Dirt water discharge hose
5 Drain hose retainer
Remove the drain hose from the holder.

Unscrew the lock from the drain hose.

The water flow can be reduced by squeezing the dos-

ing unit.
Hook the drain hose in the support after emptying and

then press it into the retainer.
The fresh water tank drain hose is located on the left-hand
side of the device.
1 Closing head
2 Bracket
3 Dosing equipment
4 Drain hose retainer
5 Drainage hose for fresh water
Remove the drain hose from the holder.

Unscrew the lock from the drain hose.

The water flow can be reduced by squeezing the dos-

ing unit.
Hook the drain hose in the support after emptying and

then press it into the retainer.
ATTENTION
To achieve an optimum cleaning result, the driving speed
should be adjusted to take specific situations into account.
During operation, the waste container should be emptied
at regular intervals.
ATTENTION
Make sure that the waste container flap is open.
Open the flap of the waste container, see chapter

"Opening/closing the flap of the waste container".
1 Switching brushes on/off
2 Raising/lowering side brushes deck
3 Switch for cleaning type: sweeping or scrubbing
4 Switch for filter dedusting
5 Engine speed potentiometer
6 Parking brake
Set motor speed to Max.

Actuate the lever and switch on the brushes; the brush-

es move downwards.
If necessary, adjust the brush contact pressure, see

Chapter "Adjust brush contact pressure".
Lower the side-brushes.

Set the switch to sweeping cleaning type (to the rear).

Release parking brake.

Begin sweeping.

In the meantime: Dedust the dust filter.

18
-
EN 19