6.2.3
Open/close flap of the waste container
6.2.4
Begin wet cleaning
ATTENTION
It is recommended to open the flap of the waste container
during sweeping.
It is recommended to close the flap of the waste container
during wet cleaning.
1 Display lamp (waste container flap)
2 Open/close flap of the waste container
Note
If the display lamp lights up, then the flap is closed.
When the display lamp lights up, actuate the lever and
open the flap.
ATTENTION
Risk of accident, risk of injury!
Keep unauthorised persons away from the cleaning ar-
ea.
Set up a corresponding warning sign.
1 Switching brushes on/off
2 Raise/lower the side scrubbing deck
3 Switch for cleaning type: sweeping or scrubbing
4 Water pump switch
5 Engine speed potentiometer
6 Parking brake
7 Water dispensing, roller brush
8 Water dispensing, side scrubbing deck
Set motor speed to Max.
Close the flap of waste container
Actuate the lever and switch on the brushes; the brush-
es move downwards.
If necessary, adjust the brush contact pressure, see
Chapter "Adjust brush contact pressure".
Actuate the lever and lower the side scrubbing deck.
Switch on the water pump.
Select the amount of additional water for side scrubbing
deck and brushes.
Set the switch to scrubbing cleaning type (to the front).
Note
The suction bar is lowered and the suction turbine
starts.
Release parking brake.
Start with the wet cleaning process.
Note
The dirt that is picked up is collected in the waste water
tank and, if necessary, in the waste container.
16
-
EN
17