ESAB KHM 405 YS Manuel D'instructions page 26

REMOTE CONTROL PHG1B-PHG1B/PL
ONLY PL
VERSION
The remote control PHG1B, which regulates the welding
current in the CC (STICK welding) mode and the welding
voltage in the CV (MIG/MAG welding) mode, is connected to
the front panel by means of a multipole connector.
When the remote control is connected to the remote control
connector (8), it is functional and automatically excludes the
front panel regulation. The remote control can also be
connected to the connector on the wire feeder front panel but
in this case it is necessary to switch the wire feeder commutator
so it can operate.
The polarity inverter (64A), if installed, can be operated from
the remote control.
Adjust the welding current control knob to the correct current
for the diameter and type of electrode being welded.
KHM
PUSH AND
SCREW TIGHT
ATTENTION
When the PHG1B is not used, it is necessary to disconnect
the multipole connector
M
38.8