Starting Up The System; Operating Notes - Balluff BTL5-H1A Serie Mode D'emploi

BTL5-H1A/C/E _ -M _ _ _ _ -A/B/Y/Z(8)-C001
Micropulse Transducer - Rod Style
5
Startup (continued)
5.4

Starting up the system

Uncontrolled system movement
When starting up, if the position measuring system is
part of a closed loop system whose parameters have not
yet been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
Persons must keep away from the system's
f
hazardous zones.
Startup must be performed only by trained technical
f
personnel.
f Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3.
Check measured values and adjustable parameters
(especially after replacing the transducer or after
manufacturer repairs). Re-adjust the transducer, if
necessary.
5.5

Operating notes

– Check the function of the transducer and all associated
components on a regular basis.
– Take the position measuring system out of operation
whenever there is a malfunction.
– Secure the system against unauthorized use.
16 english
DANGER