Short Instructions - LaserLiner DualAxis-Laser Mode D'emploi

DualAxis-Laser

Short instructions

Switching the
unit on for the
(34)
first time
Remote control
Rotating speed
(35)
Digital slope
function
(27) (31)
(28) (28)
(29)
Manual slope
function
(32)
18
Switch the unit on using the ON/OFF button (34). The
laser rotates at a speed of 600 rpm and the automatic
sensors are active.
The remote control can be used to control all functions
except slope entry. Standby mode is a special feature:
press the standby button (36) to switch the DualAxis-
Laser to standby mode. All settings are retained.
Press the rotation button (35) to switch speeds (0; 300;
600; 1100 rpm).
Press the X button (27): The first digit starts to flash.
Press the plus/minus buttons (28) to enter a positive
(„0") or negative value („-"). Press the X button to
select the values of subsequent digits. Numerical values
can be set using the plus/minus buttons (28). The Y but-
ton functions in the same way as the X button.
Important: You must confirm your entries by pressing
Enter (29); the rotary laser will then set the required
value. Value entry is disabled during levelling („SLOPE"
flashes on the LCD (19)). Once levelling is complete and
value entry has been reactivated, „SLOPE" will stop flas-
hing and will be displayed permanently on the LCD.
This function is used to deactivate sensor automation.
Significant deviations from the horizontal and vertical
planes can now be configured. To do this, press the
auto/man button (32). „MAN" will appear on the LCD
(24). Note: The DualAxis-Laser is not capable of motori-
zed slope traversal in auto/man mode. Important: Since
the automatic sensors are not active, horizontal levelling
is not possible.
ENGLISH