LaserLiner DualAxis-Laser Mode D'emploi page 19

Tilt
function
(33)
Laser segment
mode
(30)
(28) (28)
(29)
Illuminated
display
(29)
Power manage-
ment
Calibration
(32) (34)
(35)
(39) (39)
(40)
Once the rotary laser has been levelled and the auto-
matic sensors are running, press the tilt button (33). It
takes approximately 30 seconds to activate tilt. If you
move the unit during this time, it will switch itself off.
The laser and „TILT" (22) flash. Press the tilt button
again to reactivate the automatic sensors; tilt will be
reactivated within approximately 30 seconds. Once the
tilt function has been activated, it can be deactivated by
pressing the tilt button again.
Important: The tilt function is not active in standby
mode.
Press the segment button (30). The top segment (21)
flashes on the LCD. Use the plus/minus buttons (28)
to activate/deactivate the segment. Press the segment
button again to move to the next segment. Press Enter
(29) to confirm the setting and transfer it to the laser.
Press and hold down Enter (29) on the rotary laser for
at least 2 seconds to activate/deactivate the illuminated
display.
The unit can run on rechargeable batteries, standard
alkaline batteries and a mains power supply. Running
the unit on a mains power supply will charge its rechar-
geable batteries.
Press and hold down the auto/man button (32). With
the auto/man button held down, press the ON/OFF
button (34) until CAL (37) appears on the display. Open
the calibration compartment on the remote control unit
and select the X axis by pressing the X/Y button (38).
You can now set the selected axis using the plus/minus
buttons (39). Proceed in the same way to set the Y axis.
Save the new setting by pressing Enter (40).
ENGLISH
DualAxis-Laser
19