LaserLiner DualAxis-Laser Mode D'emploi page 20

DualAxis-Laser
Operation of the DualAxis-Laser
Charging the batteries
• The battery symbol (26) will flash constantly on
the LCD (I) to indicate that the batteries need
changing or recharging.
• Open the battery compartment (K), insert the
batteries and connect the plugs to the sockets.
The plugs fit in the sockets in one position
only (see pictures on right). Reclose the battery
compartment.
• Connect the battery charger/mains unit to
a mains source and plug into the socket (F).
Please only use the charger/mains unit supplied
with the device. If a different one is used, the
warranty will become void.
• The device can also be operated with standard
alkali batteries (4 x type D). Insert the batteries as shown by the installation symbols.
Ensure the polarity is correct.
Inserting batteries into the SensoLite laser receiver
• Open the battery compartment (8) and insert the battery according to the installation
symbol, making sure that you do not reverse the polarity. Replace the cover.
• In order to save battery power the receiver will switch itself off automatically after
approximately 5 minutes of inactivity.
Note:
Do not expose batteries to excessive heat such as sunshine, fire, etc. Dry batteries must
not be recharged. Used batteries must not be disposed of as household waste. Please
take them to a collection point for used batteries or for special waste. Ask your local
authority for further details. Batteries with the recycling symbol can also be returned to
our dealerships or to our Technical Service.
20
i
Deutsch
ENGLISH
1