Standby Mode; Tilt Function - LaserLiner DualAxis-Laser Mode D'emploi

Set-up
• Set the unit up on a surface that is as level as possible or fasten it to a
tripod.
• Press the ON/OFF button (34) on the rotary laser.
• The unit will level itself automatically to within +5°. Once levelling is com-
plete, the laser will rotate at a speed of 600 rpm. The speed can be modified (0, 300,
600, 1100 rpm) using the rotation button (35). The laser will flash whilst the laser is
being aligned.
Important: The high measuring accuracy means that automatic levelling can take up
to 3 minutes.
Note: If the unit is set to an excessive angle (out of its 5° range), a warning signal will
sound and the rotary head will stop turning. The unit must then be placed on a more
even surface.
• BackLight: Press and hold down Enter (29) on the rotary laser for at least 2 seconds
to switch the illuminated display on. Press the button again to switch it off.
• Press 17 to switch the SensoLite laser receiver on. The laser beam can now be
received. Please note that the laser receiver will respond more quickly if the rotary
laser is set to a high speed.

Standby mode

• The ON/OFF button (37) on the Commander DA 50 can be used to switch the rotary
laser to standby mode. All preset values are retained (highly recommended in digital
slope mode).
• Note: If the rotary laser is switched off directly by pressing the ON/OFF button (34) on
the unit, all preset values will be deleted.

Tilt function

• To protect the unit against drift due to external influences, you must
activate the tilt function. To do this, press the tilt button (33) (see the
section about the anti-drift system for more information). „Tilt" (22)
appears permanently on the LCD to indicate that the tilt function is active.
• Note: The tilt function is not active in standby mode and the unit is not protected
against drift.
i
ENGLISH
DualAxis-Laser
25