Connecting To A Stimulator - Axonics 2501 Manuel

Connecting to a Stimulator

The CP will automatically search for the nearest Stimulator ( 1 ).
2
A scrolling search icon will appear when the CP is searching for
1
Stimulators ( 2 ).
The CP will display the nearest patient device ( 3 ). Check the
Device ID and the Patient ID to determine if this is the correct
7
device. New devices will not have Patient IDs.
3
4
Press "Connect" ( 4 ) to connect to the displayed device. The
CP will display a prompt while it connects to and retrieves data
6
from the Stimulator ( 5 ). When connected to the device, the CP
will automatically open the Patient Device screen.
Additional devices can be displayed by the CP if the first device
5
found is not the targeted Stimulator. Press the down arrow
next to "Show Additional Devices" ( 6 ). This will display up to 3
additional devices found in proximity of the CP.
Note: Hold the CP within 1 meter (~ 3 feet) of the targeted device to find the
device. If the desired device is not found, move closer and search again by
pressing "Scan Again" ( 7 ).
34 34