Table - Pelgrim GK364 Notice D'utilisation

81
Fault
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
faults

Table

If the appliance does not work properly, it does not always mean that it
is defective. Try to deal with the problem yourself first. Phone the service
department if the advice given below does not help. See the guarantee
certificate or consult the internet site www.pelgrimservice.nl. Only authorised
personnel may carry out work on the gas and electrical part.
Cause
- A burner is turned on but
not lit.
- The coupling on a bottled
gas unit has come undone.
- Burner parts not correctly
installed.
- Fuse defective/fuse in meter
cabinet switched off.
- Plug not in socket.
- Sparkplug dirty/damp.
- Burner parts dirty/damp.
- Main gas tap closed.
- Fault in the gas network.
- Gas bottle or tank is empty.
- Control knob not kept
pressed in long enough or
far enough.
Solution
- Close the tap and wait
for a few minutes before
relighting.
- Tighten the coupling.
- Assemble the burner parts
using the centring ridges and
ensure that they fit properly
together.
- Fit a new fuse or switch the
automatic fuse back on.
- Push the plug into the
socket.
- Clean and dry the sparkplug.
- Clean and dry the burner
parts, making sure that the
outflow holes are open.
- Open the main gas tap.
- Check with your gas supplier.
- Connect a new gas bottle or
have the tank filled.
- Keep the control knob
pressed in far enough
between full and low.