Cleaning And Storing The Device And Cuff; Advice On Use - Beurer BM 67 Mode D'emploi

• To conserve the batteries, the monitor switches
off automatically if no buttons are pressed for one
minute.
• The device is only intended for the purpose de-
scribed in these instructions for use. The manu-
facturer is not liable for damage resulting from im-
proper or careless use.
• If you are using the unit for the first time, please re-
move the protective film from the display.
• The monitor can maintain the safety and per-
formance characteristics for a minimum of 10.000
measure ments or 3 years.
• Further documents which include information for
the Calibration of the device can be asked at the
service address.
• The device can be tested in case of supposed
inaccu racy every two years. Please contact the
nearest ser vice address.

Cleaning and storing the device and cuff

To keep your digital blood pressure monitor in the best
condition and protect the unit from damage follow the
directions listed below:
• Clean your device and cuff carefully only with a
slightly moistened soft cloth and dry it immediately
with a soft dry cloth. Do not press.
• When storing the device, make sure that no heavy
objects are placed on top of it.
• Do not fold the cuff and tubing tightly. The cuff tube
should not have any sharp kinks and keep it away
from sharp edges.
• If the unit is stored near freezing, allow it to acclim-
ate to room temperature before use.
• Always store the unit in its storage pouch after use.
• This unit may not meet its performance specifica-
tions if stored or used outside of the temperature and
humidity ranges (see section '12. Specifications').
• Use the unit consistent with the instruction provided
in this manual.

Advice on use

• For consistency, always measure your blood pres-
sure at the same time each day.
• Always wait at least 5 minutes between measure-
ments to allow the blood circulation in your arm to
return to normal. You may need to increase the wait
10