Iii-A. Description (Multi-Temperatures Model 5059S - 5259S); Iii-B. Temperature Settings; Humidity Level Display; Lighting Mode Adjustment - Eurocave 5000 Série Mode D'emploi

6/ USING YOUR WINE CABINET FOR THE FIRST TIME

III-A. Description (multi-temperatures model 5059S - 5259S)

A B C D E F C
O N M L
A
Lighting mode
B
Door open alarm
C
Temperature zone concerned
D
Fault sensor alarm
E
Temperature alarm
F
Carbon filter alarm
G
Validation and settings access button
H
Selection and adjustment buttons

III-B. Temperature settings

Recommended setting range for the lowest temperature: 7 to 9 °C (45° to 48 °F).
Recommended setting range for the highest temperature: 17 to 20 °C (62° to 68 °F).
5 sec.
Press the key for 5 s to activate.
1
Press the key about 5 s.
The display starts to flash.
3
Press the button to validate.
The right-hand display is flashing.
The value on the display is the actual temperature inside the
cabinet, it is therefore necessary to wait before your new setting
takes effect.
16
GB
G H I
The touch keys are very sensitive. There
is no need to push the keys very hard. A
simple, gentle touch is enough to
register the setting. Think to lift your
finger from the control panel between
each touch.
K J
I
Lighting mode validation and access button
J
Carbon filter counter log access button
K
Power button
L
Highest cabinet temperature display
M
Hot circuit indicator light
N
Cold circuit indicator light
O
Lowest cabinet temperature display
2
Press the or keys to set the temperature of the lower
section of the cabinet.
4
Press the or keys set the temperature of the upper section
of the cabinet
5
Press the button to validate.
•
The default setting for the lowest temperature range is 8 °C (46 °F).
However, this setting can be adjusted between 5 and 12 °C (41° and
54 °F).
•
The default setting for the highest temperature range is 18 °C (64 °F).
However, this setting can be adjusted between 15 and 22 °C (59° and
72 °F).
WARNING: to operate correctly your cabinet should be located in a
room with a temperature between 12 and 30 °C (54° and 95 °F).
6/ USING YOUR WINE CABINET FOR THE FIRST TIME
IV. Humidity level display
Your wine cabinet is fitted with a function for measuring the level of
hygrometry, enabling you to visualise the level of relative humidity inside
the appliance, when the setting is 9 - 15° C.
The ideal level of hygrometry is above 50 %, ideally located between 60
and 75 %.
V. Lighting mode adjustment
1
Press the button.
The active mode light flashes.
There are 3 possible lighting settings:
Lighting all the time (for mood lighting when using a glass door
cabinet, for example).
Lighting when door opens (it goes out when the door is closed).
Lighting disabled.
VI. Carbon filter counter log display
When activating or replacing the filter, adjust the counter to 365.
1
Press the key.
The display is flashing.
3
Press the button to validate.
The alarm display go out.
If you would like to increase the level of relative humidity in your cabinet,
pour the equivalent of a glass of water on the humidity cassette. You need
to remove the bottles before.
2 sec.
2
Press the or keys to set the desired mode.
3
Press the button to validate.
The alarm display go out.
Usage precautions: intense light, never look directly into
the beam.
2
Press the key to adjust to 365.
You can consult the counter by pressing the key.
17
GB