LawnMaster NPTGCP2617A Manuel D'utilisation page 25

MAINTENANCE
■ Refer to the Line Replacement section in this manual if only the line needs to be replaced.
■ Insert the new spool into the spool cover. Release both trimming lines from the parking slot and
guide the lines into both eyelets (Fig. 28).
■ To reinstall the spool cover, first align the arc area on the spool cover with the locking tabs on
the trimmer head housing as shown. Then press the locking tabs and push the spool cover onto
the trimmer head housing. Make sure they are secured tightly (Fig. 29).
LINE REPLACEMENT
■ You may wind new cutting lines onto an empty spool.
■ Replacement cutting line is available from the dealer.
■ Remove the empty spool from the grass trimmer as described above.
■ Remove any remaining cutting line from the spool.
NOTE: Use only round monofilament line with the recommended diameter.
■ Ensure that the new cutting line is sufficiently long, approximately 13 ft (4 m). Fold the line in half
and then adjust it so that one end is approximately 3.5 in. (9 cm) longer than the other (Fig. 30).
■ Hook the folded end of the cutting line onto either of the slots in the spool (Fig. 31).
■ Wind the line onto the spool. Wind the line in the "RH" direction indicated on the spool.
■ Place the ends of the line in the two opposite parking slots of the spool, leaving some of the line
out (Fig. 32).
Locking tabs
on the trimmer
head housing
Fig. 28
(See Figs. 30-32)
Fig. 30
25
Fig. 29