Safety
– Disconnect system from the power supply.
– Attach a warning sign: "Do not switch on! The system is
being worked on."
– Ensure that the system is free of voltage.
Check the electrical system regularly to ensure it is in proper
working condition.
Pos: 33 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Heiße Oberfläche Motor @ 0\mod_1427781274683_370.docx @ 26707 @ 3 @ 1
2.7.4
Hot surfaces
The electric motor can reach temperatures of up to 70 °C. There
is a risk of being burned.
Do not touch the motor during operation.
Allow the pump/unit to cool down before servicing it.
Pos: 34 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Gefahrstoffe @ 0\mod_1427782200424_370.docx @ 26722 @ 3 @ 1
2.7.5
Hazardous materials
Ensure that leaks of dangerous pumped fluids/gases are led
away without endangering people or the environment.
Decontaminate the pump completely during disassembly.
Pos: 35 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Ansauggefahr @ 0\mod_1427783303305_370.docx @ 26737 @ 3 @ 1
2.7.6
Suction danger
Ensure that the suction openings conform to current guidelines,
standards and instructions.
Pos: 37 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Störungen/Störungen @ 0\mod_1427783778053_370.docx @ 26752 @ 2 @ 1
2.8
Faults
In case of a fault, immediately switch the pump off and
remove it from operation.
Have all faults repaired immediately.
Pos: 39 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Störungen/Festsitzende Pumpe @ 0\mod_1427784418208_370.docx @ 26767 @ @ 1
Seized pump
If a pump seizes, and is switched on several times repeatedly, the
motor can be damaged. Observe the following points:
Do not switch the pump/unit on repeatedly.
Turn the motor shaft by hand. See point 6.1.2 on page 21.
Clean pump.
Pos: 40 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
10 EN
04|2017