Starting Up - Gram BAKER GA 500 Mode D'emploi

Starting up

Program selection/stop
= Main switch.
The switch is located behind the control panel. To
access the switch, open the panel by pulling its
left-hand side outward.
On switching the cabinet on, the green chilling
lamp and the P key light up and "G122" is shown
in the display for 10 seconds, then "OFF" is
shown. The cabinet is now operating in stand-by
mode.
Servicing:
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the main switch
as there will still be voltage to some electrical parts of the cabinet.
Settings to be made before use:
The following settings are to be made before the cabinet is taken into use:
the season, the time setting, the weekday, the year, and choice of language.
These settings are quite simple to do, and should only be done once.
There are exceptions in certain situations.
If the cabinet is without power supply due to power failure, or if it is switched off
at the mains for more than 24 hours, the settings which may have been done, will
be lost.
The personal settings of the various programmes will be lost, too.
765041584
Proving
Retarding
Storage
Chilling
P
+ key
- key
Rev 000
Display
S
Start
43