General Use - Gram BAKER GA 500 Mode D'emploi

Always disconnect the power if interruptions in power supply occur, and when electrical parts
are removed/put on, and before cleaning and maintenance of the appliance.
Repairing of electrical/technical parts may only be performed by a service electrician from Gram
Commercial or an authorised refrigeration company with knowledge of Gram's products.
Do not use the appliance before all coverings are installed, so that live or rotating machine parts
can not be touched.
The cabinet is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The
cabinet plug and wall socket should then give correct earthing. If necessary, contact an
electrician.
Make sure the appliance is switched off at the socket before service is
performed on electrical parts. It is not sufficient to switch off the cabinet
by the START/STOP key as there will still be voltage to some electrical
parts of the cabinet..

General use

Do not block vent holes in the front panel.
Do not damage the refrigeration system parts.
During normal operation, some parts of the refrigeration system in the
compressor compartment might reach high temperatures, and could therefore
cause burns if touching these components.
Do not use electrical devices inside the cabinet.
To ensure correct and efficient air flow in the cabinet, the shaded areas must be
kept free of products. (see Fig. 7)
All products to be stored, that are not wrapped or packed, must be covered in
order to avoid unnecessary corrosion of the inner parts of the cabinet.
If any controller parameters are changed from default, this could cause that the
appliance is not functioning normally, and harmful temperatures could damage
products that are kept inside the appliance.
If the appliance is turned off, wait minimum 3 minutes before turning the
appliance on again. This is to protect the compressor from damage
765041584 Rev 000
41