Balancing The Beam - Seca 745 Mode D'emploi Et Garantie

Balancing the beam

3. 3.
2.
3. Push both sliding weights to the "0" position.
4. Wait until the beam has stopped swinging.
NOTICE!
Incorrect measurement due to force shunt
If you touch the scale, weight will not be
measured correctly.
– Ensure that you do not touch the scale while
the beam is swinging.
5. Check whether the beam is balanced.
The pointer and counterpointer must be at exactly
the same level.
6. If the pointer and the counterpointer are not at ex-
actly the same level, balance the beam as de-
scribed in the section below.
1. Ensure that both sliding weights are in the "0"
position.
2. Undo the knurled screw on the tare weight.
3. Move the tare weight to balance the beam.
4. Wait until the beam has stopped swinging.
NOTICE!
Incorrect measurement due to force shunt
If you touch the scale, weight will not be
measured correctly.
– Ensure that you do not touch the scale while
the beam is swinging.
English
Operation • 37