Pan & Tilt Connection To Dtmrx1/Dtrx3 Receiver; Preset Connection To Dtrx3Receiver (Only Pth310P / Pth311P) - Videotec PTH310 Manuel D'instructions

Pan & tilt connection to DTMRX1/DTRX3 receiver
WARNING: before the connection, make sure that the output voltage of the receiver corresponds to pan & tilt
voltage (Refer to the identification data of the pan & tilt motor and to DTMRX1/DTRX3 manual).
Where to operate : J1 terminal block in the upper printed circuit of the pan & tilt motor (see drawing), terminal block of
the receiver (see DTMRX1/ DTRX3 manual)
Adjustments : connect the terminal block J1 of the pan & tilt motor to that of the receiver according to the following table
Preset connection to DTRX3 receiver (only PTH310P / PTH311P)
The following procedure has to be carried out only for PRESET pan & tilt motors and connected to DTRX3
receiver.
Where to operate : J4 terminal block in the upper printed circuit of the pan & tilt motor, preset terminal block (see
DTRX3 manual)
Adjustments : connect the J4 terminal block of the pan & tilt motor to the preset terminal block of DTRX3 according to
the following table:
Connection to DTRX3
Vcc
Pan
Tilt
Gnd
Connection to the receiver
COM
DOWN
UP
RIGH
LEFT
AUTO
Terminal block J1 (Pan & Tilt)
Com
Down
Up
Right
Left
Auto
Meaning Terminal block J4 (Pan & Tilt)
+5 Volt Vcc
Horizontal Pan
Vertical Tilt
0 Volt Gnd
Pag. 9 PTH310 / PTH311 3201