Transport And Start Up; Transport And Installation; Assembly; Mains Connection - Promac BX-825VT Mode D'emploi

M....Spindle OFF switch
N....Spindle ON switch
O.... Emergency stop button
P.... Drill / Tap select switch
R....Speed select wheel (Variator)
S.... Pulley cover

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on a firm and levelled table surface.
A minimum distance of 800mm towards a rear wall must be
kept (for access to the electrical box).
The machine must be bolted down. The base (F, Fig 1) has
two holes for the mounting bolts.
For packing reasons the machine is not completely
assembled.

5.2 Assembly

If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent e.g.
petroleum.
(Note: lacquer thinner or similar can destroy the paint).
Install three down feed handles (C, Fig 1) onto the bar and
together onto the hub.
Install the table rising handle (E).
Install the variable speed select wheel (R).
Install the chuck guard (I).
Mounting machine to workbench or base:
Unbolt the machine from the shipping crate.
Use heavy duty fibre belts (AA, Fig 3) for lifting the machine
off the pallet.
Fig 2
Caution:
The machine is heavy!
Assure the sufficient load capacity and proper condition
of your lifting devices.
Never step underneath suspended loads.
Carefully place the machine to workbench or base.
Use 2 bolts of sufficient size and length.
Use a machinist's precision level to make sure that the
machine table is level.
Loosen mounting bolts, shim and tighten mounting bolts if
needed.
The machine must be level to be accurate.
Attention:
To secure the stability the workbench or cabinet stand has
to be bolted down on the floor by using anchor bolts of
sufficient size and length.

5.3 Mains connection

Mains connection and any extension cords used must
comply with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may
only be carried out by qualified electricians.
ATTENTION:
- If the direction of rotation is not correct, the phase
converter inside the CCE Euro plug must be pushed in and
turned 180°.

5.4 Starting operation

6
Fig 3
125kg!