Getting Started - Eccotemp SMARTHOME ESH-2.5 Manuel D'utilisation Et D'entretien

Getting Started

FILLING THE WATER HEATER
Before connecting the power, fill
the tank and system with water and
check for leaks. To be sure that all
remaining air is out of the water
system, open the hot water faucets
on your fixtures until constant water
flows. Any air remaining in the tank
will cause the water heater element
to fail.
1. Open the hot water faucet.
2. Open the cold water supply valve.
3. When continuous water flows out
of the faucet, the tank is filled.
4. Close the hot water faucet.
5. Check entire system for leaks.
POWERING THE WATER HEATER
CAUTION! Before powering the water heater, be sure that the system is
completely filled with water and ALL AIR IS REMOVED.
To be certain that all of the air is out of the water heater, open the HOT water
faucet on the fixtures until constant water flows from them. If air remains in the
tank, the element will be damaged when the electric cord is plugged in.
The Eccotemp SMARTHOME Mini Tank water heater comes equipped with
a power cord that is intended to plug into a standard 110/120v receptacle.
Adhere to all pertinent state and local codes. The Eccotemp SMARTHOME Mini
Tank was manufactured and wired in accordance with ETL requirements.
Powering Your Eccotemp SMARTHOME Water Heater:
1. Plug your Mini Tank to a grounded outlet.
2. Adjust the temperature of the water heater either by the manual temperature
controls or the SMARTHOME app. Manual temperature controls are located
towards the back on the right side.
3. Allow up to 25 minutes to achieve desired set temperature.
The Eccotemp SMARTHOME Mini Tank Water Heater comes equipped with an
overheat sensor with a manual reset; also known as the temperature high limit.
This device has been factory installed to interrupt the power supply in the event
of a thermostat failure. The manual reset is located on the back of the mini in
the middle at the bottom. If you have wall mounted your water heater, you may
need to unmount it to reach the reset switch.
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Support: Support.Eccotemp.com
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Shop Online: Eccotemp.com
3/4 T&P
Relief Valve
Manual
Control
Knob
Store Locator: Eccotemp.com/locator
Power
Cord
13