Setting Temperature; Temperature Dial - Eccotemp SMARTHOME ESH-2.5 Manuel D'utilisation Et D'entretien

Getting Started

SETTING TEMPERATURE

WARNING! This water heater is designed for 110/120v service - DO
NOT CONNECT TO ANY OTHER VOLTAGE. Failure to use proper voltage
may result in personal injury and/or property damage. If the supplied
electrical power cord is either damaged or not long enough, do NOT use an
extension cord. Have a licensed electrician replace the power cord.
Congratulations! You are now ready to use your water heater. Run the hot
water at a nearby sink and evaluate the hot water temperature. Make any
temperature adjustments using the section below.
ADJUSTING YOUR THERMOSTAT

Temperature Dial

*Right Rear of Water Heater
Manual Mode: Turn the dial in either direction to adjust your temperature up
or down. Turn clockwise to increase temperature and turn counterclockwise
to decrease temperature. Repeat this step until you achieve your desired
temperature.
Using the App: When your Mini Tank temperature dial is set to WIFI, it will
connect to your smart devices and smart phone to allow you to change the
temperature and access the app's other features.
Note: When in manual mode you WILL NOT be able to control the Mini Tank
remotely through the SMARTHOME
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
16
Support: Support.Eccotemp.com
WIFI
Power
Cord
app.
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Shop Online: Eccotemp.com
Device Name
Unit of Measure
(Degrees)
Current
Temperature
Temperature
Control Slider
Quick Set
Buttons
Store Locator: Eccotemp.com/locator