Hot Water Connection - Eccotemp SMARTHOME ESH-2.5 Manuel D'utilisation Et D'entretien

Installation Instructions
WATER CONNECTIONS
Water connections should be in close orientation to the install site. Confi rm there is
enough allowance for the water intake and outtake hoses to reach the water heater.
Note: If your water pipes are copper or bronze be sure to use dielectric
connections to prevent corrosion. Failure to do so may cause damage to your
tank and void your warranty. In order to protect the water heater from heat
damage due to soldering, solder a piece of tubing to a threaded union fi tting
before screwing the union to the tank.
1. Install a shut off valve in line with the cold-water pipe.
2. Connect the cold water pipe to the inlet nipple, marked with a blue label.
3. Connect the hot water pipe to the outlet nipple, marked with a red label.

Hot Water Connection

1/2 Inch NPT
IMPORTANT: Failure to provide dielectric insulation may result in premature tank
or nipple failure and may void your warranty. The Temperature & Pressure Relief
valve (T&P valve) is for servicing and the valve should be in the open position
when the water heater is in operation. DO NOT APPLY HEAT DIRECTLY TO INLET
OR OUTLET CONNECTIONS.
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
10
Support: Support.Eccotemp.com
NOTICE: Do not attempt to remove rubber washer.
View of the Top
Shop Online: Eccotemp.com
Front
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Cold Water Connection
1/2 Inch NPT
Temperature & Pressure
Relief Valve 3/4 Inch NPT
Store Locator: Eccotemp.com/locator