Installation Instructions; Choose A Location; Wall Mounted - Eccotemp SMARTHOME ESH-2.5 Manuel D'utilisation Et D'entretien

Installation Instructions

A licensed professional should complete the installation adhering to all state
and local codes. The manufacturer will not be liable for any damages because
of failure to comply with these installation instructions or because of improper
installation performed by an unqualified installer.

CHOOSE A LOCATION

Select a location that allows ease of access for maintenance, ideally with at
least 9 inches of clearance at the top from any ceiling or cabinet interior.
Note: Only install in a vertical position.
Free Standing
Sit on the floor under a sink or in a
cabinet, upright, as pictured in the
diagram below and on the front cover
of this manual.
Note: Make sure to leave at least nine
(9) inches of clearance above your
water heater.
Free Standing on Floor
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Support: Support.Eccotemp.com
THE FUTURE OF EFFICIENCY
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Shop Online: Eccotemp.com

Wall Mounted

Fasten the supplied mounting
bracket to the wall. Use screws that
are suitable for the wall material and
the weight of the water heater filled
to capacity. The ESH 2.5, when full,
weighs 41 lbs. The ESH 4.0, when full,
weighs 58 lbs. Hang the water heater
on the bracket and pull downwards
on the water heater to ensure that
both fingers of the bracket are seated
in the mounting slots.
Note: Confirm your water piping
orientation (hot and cold) before
wall mounting.
ESH 2.5 = 10.9 Inch
ESH 4.0 = 12.5 Inch
Wall Mounted
Store Locator: Eccotemp.com/locator
Wall
Anchor
Temperature
Control
Do Not Block
9