Starting Up; Filling Up - Grizzly BHS 2670 E2 Traduction De La Notice D'utilisation Originale

GB
environments is prohibited.
The operator or user is liable for acci-
dents, injury to humans or damage to their
property.
The manufacturer shall not be liable for
damages caused by non-intended or inap-
propriate operation.

Starting up

After turning off the appliance,
the blades will keep moving for a
short while. Allow the blades to
come to a halt, do not touch the
moving blades and do not slow
them down. Risk of injury!
Read the safety instructions be-
fore starting the appliance. Do not
operate the appliance without the
hand guard. To operate the appli-
ance, wear suitable clothing, work
gloves as well as head, eye and
ear protection. Prior to every use,
check that the appliance is opera-
tive. Only use OEM parts.
Before operating the device, you must fill
it with fuel.

Filling up

Ensure proper ventilation when
handling fuel. Do not smoke
when filling up and keep away all
heat sources. Do not fill up when
the motor is running or still hot.
Carefully remove the filler cap to
allow any excessive pressure to
relieve slowly. Do not start the
appliance near the place of fill-
ing up. Use suitable and admis-
sible vessels to keep the fuel in.
Non-compliance causes a risk of
fire or explosion.
76
Use the fuel mixture recommended
in the manual only. Verify that it is
no older than 3 months. Non-com-
pliance may damage the motor and
your warranty will be voided..
Prevent petrol from coming into
contact with your skin and do not
inhale petrol fumes. Health risk!
The appliance runs on a 40:1
mixture of unleaded petrol
and two-stroke engine oil (API
TC quality).
Table of fuel mixtures:
Petrol Grizzly two-stroke oil
3,00 litres
4,00 litres
5,00 litres
40 parts of petrol + 1 part
Mixing
• Do not use undiluted fuel. Only use
two-stroke oil (no four-stroke oil or oil
for water-cooled engines). Non-com-
pliance may damage the motor and
your warranty will be voided.
1. Prepare the petrol/oil mixture in a
clean canister intended for use with
petrol.
2. First fill in half of the petrol, then all
of the oil, then shake the canister. Fill
in the rest of the petrol and shake the
canister again.
3. Remove the filler cap and fill the fuel
mixture into the petrol tank. Wipe
spilled fuel from around the filler open-
ing and replace the filler cap.
75 ml
100 ml
125 ml
of oil