Cleaning The Air Filter; Replacing / Adjusting The Spark Plug; Adjusting The Carburettor; Storage - Grizzly BHS 2670 E2 Traduction De La Notice D'utilisation Originale

spray the appliance with water and do
not immerse it in water.
• Do not use cleaning agents or solvents.
You may otherwise irreparably damage
the appliance. Chemical substances
may damage the plastic parts of the ap-
pliance.
• Carefully clean the blade bar after every
time of use. Wipe with an oily cloth or
spray it with a metal care spray.
Cleaning the air filter
Do not operate the appliance
without the air filter. Dust and
dirt will otherwise get into the
engine and cause damage to the
machine. Keep the air filter clean.
The air filter (20) is located behind the
cover below the choke lever.
1. Turn off the unit.
2. Unscrew the air filter cover (15).
3. Remove the air filter (20) from its
housing.
4. Clean the filter with soap and water.
Do not use petrol for cleaning!
5. Air-dry the filter.
6. Reverse the above order of steps to
replace the filter.
Use a new air filter to replace a worn-
out, damaged or very dirty filter.
Replacing / adjusting the
spark plug
Worn-out spark plugs or the spark gap
being too wide will reduce the power of
the engine.
1. Turn off the unit.
2. Pull the ignition cable (5) off the
spark plug.
3. Use a spark plug wrench to
remove the spark plug (6) by
turning it anti-clockwise.
4. Use a feeler gauge (available in
specialised shops) to check the
spark gap.
Electrodes to be 0.6-0.7 mm
apart
5. Adjust the gap by carefully ben-
ding the bow of the spark plug
as necessary.
6. Use a steel brush to clean the
spark plug.
7. After cleaning and adjustment,
put the spark plug back in or
replace a damaged plug with a
new one.
8. Put the ignition cable back on.

Adjusting the carburettor

The carburettor has been set for optimised
performance in the factory. Any readjust-
ments that may become necessary should
be made by an expert.

Storage

General storage instructions

• Carefully clean the appliance and
its accessories as a means against
mould (see Maintenance and Clean-
ing).
• Keep the appliance in a dry and dust-
proof place and out of the reach of
children.
• Do not wrap the appliance in plastic
sacks because this may promote hu-
midity and mould.
GB
79