Publicité
During construction
The receiving system components and control surface linkages should be installed at
the appropriate stage of assembly, as described in these instructions, as it may be
very difficult or even impossible to fit them later.
The building instructions
In general terms the instructions reflect the sequence of assembly. The notes below
are intended to explain certain additional points of construction.
You may wish to alter the order of assembly; this should not cause problems, but
please think carefully about the consequences of any change you make.
Bear in mind that tools such as balsa knives, modelling pins, the ends of thin wire etc.
are sharp or pointed, and can cause injury if not handled with due care.
Ensure that children do not have access to tools, adhesives and paints.
When using solvent-based glue be sure to work in a well-ventilated room.
Take waste adhesives and paints to your nearest toxic waste collection point.
An unobstructed work area of generous size is very helpful for all types of modelling
activity.
If you are a beginner to modelling and are not sure about any of the more difficult
processes, ask an experienced modeller for advice and help.
Rules of behaviour
Never fly your model from a public road, path or square, or in the vicinity of buildings
or high-tension overhead cables.
Don't fly your BO 209 MONSUN in nature reserves, protected areas or SSSIs (Sites
of Special Scientific Interest). Please have respect for the animals and plants which
live in and around your flying site.
Bear in mind that trees and bushes are the living space and nesting sites of birds,
and should not be disturbed unnecessarily.
Never endanger animals, spectators or other pilots.
Radio control system for the BO 209 MONSUN
The following items represent the minimum equipment for this model:
1
mx-12 computer RC system, 35 MHz band
4
DS 361 servo
1
R 700 micro-receiver
2
Servo extension lead
2
Servo extension lead
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
Order No. 4722
Order No. 5159
Order No. 3551
Order No. 3935.11
Order No. 3935.32
32
01/2008
Publicité
