GYS NEOPULSE 220 C Mode D'emploi page 48

Important: The cable calibration must be repeated each time the torch, harness or ground cable is changed to ensure optimal welding.
PORTABILITY
This feature allows you to save the welding configuration of the machine.
It also allows you to load a recovered configuration on another machine and inject it into another.
Import Config. : Importing a USB key or «USER» configurations and its JOBS.
Export Config. : export to a USB key of the current «USER» configuration and its JOBS in the USB directory
JOB import: import of JOBS present under the USB directory Portability of a USB key.
JOB export: export of JOBS to a USB key according to the processes, in the USB\Portability directory.
TRACEABILITY
This welding management interface is designed to trace/record all the steps of the welding operation, bead by bead, during manufacturing. This
quality based approach enables post-production analysis, evaluation, reporting and documentation of the recorded welding parameters.This func-
tionality allows the accurate and fast collection and storage of the data requested under EN ISO 3834. The recovery of this data is possible via an
export to a USB stick.
1- Creation of traceability
Select «START»
4- Full traceability
48
NEOPULSE 220 C / 220 C XL
2- Creation of the project
Select «REC»
Definition :
- ON
• A welding CORD corresponds to a welding cycle.
• The PASS corresponds to welding over the entire perimeter of the part to be welded.
• The WELD is the end junction of the two joined up plates. The weld is therefore made of
one or more passes.
• The PROJECT is made of one or more finished welds.
• Temperature
• Length* ON : Cord length
the measurement units are displayed based on the selection defined in PARAMETERS/Units.
*
ON : Temperature of the plate to be welded at the beginning of the cord.
*
3- Simple traceability
Project name
Sampling interval :
- Hold: No recording of Current/Voltage
values.
- 250 ms, 500 ms, etc. : Recording of cur-
rent/voltage values every X times.
EN
- OFF