GYS NEOPULSE 220 C Mode D'emploi page 47

PROCESS
This menu allows you to choose the welding process: MIG-MAG
PARAMETERS
The display mode gives access to more or less welding parameters and configurations.
- Easy: display and reduced functionality: no access to the welding cycle.
- Expert: complete display, allows to adjust the duration and time of the different phases of the welding cycle.
- Advanced: full display, allows to adjust the different arc voltages in each phase.
The name of the device and the possibility of customizing it.
Supported languages: French, English, etc
The Units of Measurement: International (SI) or Imperial (GB/USA).
Naming material: EN (European) or AWS (USA)
Example: Fe (EN) -> Steel (AWS), CrNi 308 (EN) -> ER 308L (AWS)
Time, date and format.
Screen brightness
Product Reset (Partial / Total) :
- Partial (default value of the welding cycle).
- Total (factory configuration).
CALIBRATION
This mode is dedicated to calibrating the speed of motorized reels. The purpose of the calibration is to compensate for variations in the
reel speed in order to adjust the displayed voltage measurement and to refine the energy calculation. The procedure once launched is
explained with an animation on the screen.
This mode is also dedicated to the calibration of welding accessories such as torch, cable + electrode holder and cable + ground clamp.
The purpose of the calibration is to compensate for variations in accessory lengths in order to adjust the displayed voltage measurement
and refine the energy calculation. The procedure once launched is explained with an animation on the screen.
NEOPULSE 220 C / 220 C XL
(GMAW) , TIG (GTAW) or MMA (SMAW)
EN
47