Transport; Environmental Protection - Stiga Park 4WD Série Manuel D'utilisation

EN
in unauthorized centres or by unquali-
fied persons will totally invalidate the
Warranty and all obligations and re-
sponsibilities of the Manufacturer.
• After each use, remove the ignition key and
check for damage.
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
Routine maintenance is essential for safety
and for maintaining a high performance level.
• Check that the cutting device screws are
properly tightened on a regular basis.
Wear work gloves when handling, dis-
assembling and reassembling the cut-
ting device.
Keep the cutting means well bal-
anced during sharpening. All
on the cutting means (disassembly,
sharpening,
and/or replacing) are demanding jobs
that require special skills as well as
special tools. For safety reasons, these
jobs are best carried out at a special-
ised centre.
• Check that the brakes work properly on
a regular basis. It is vital for brakes to
undergo regular maintenance and, where
necessary, repair work.
• Replace any instruction or warning
message stickers, if damaged.
• If the machine does not have mechanical
transport stops, the attachments must
always be placed on the ground when
the machine is parked, stored or left
unattended.
• Store the machine out of the reach of
children.
Do not store the machine with fuel
in the tank in an area where fuel va-
pours could reach a flame, a spark or a
strong heat source.
• Allow the engine to cool before storing in
an enclosed space.
• To reduce fire hazards, keep the engine,
muffler, battery compartment and petrol
storage area free of grass, leaves, or
excessive grease.
• To reduce the risk of fire, regularly check
the machine for oil and/or fuel leaks.
10
balancing, reassembly
ENGLISH
• If the fuel tank has to be emptied, this
should be done outdoors once the engine
has cooled down.
• Never leave the keys in the ignition or
within reach of children or unauthorised
persons. Always remove the ignition key
before doing any maintenance.
WARNING! - The acid contained in the
battery is corrosive. It could leak in
case of mechanical damage or over-
charging. Avoid inhalation and contact
with any part of the body.
Inhaling acid vapours causes damage
to mucous membranes and internal
organs. Seek medical attention imme-
diately.
work
WARNING! - Do not over-charge the
battery. Excessive charging can cause
it to explode causing the acid to leak.
WARNING! - Acid causes severe dam-
age to tools, clothing and other mate-
rials. Immediately rinse the affected
area with water.
Never short-circuit the battery termi-
nals. The resulting sparks could cause
a fire.
PAY ATTENTION to hydraulic compo-
nents. Escaping hydraulic fluid under
pressure can penetrate and severely
damage the skin, requiring immediate
medical attention.
3.5

TRANSPORT

WARNING! - If the machine must be
transported on a truck or trailer, use
ramps with suitable resistance, width
and length.
During transport, close the fuel stop-
cock (if fitted), lower the cutting device
assembly or attachment, engage the
parking brake and fasten the machine
securely with ropes or chains to the
hauling device.
3.6

ENVIRONMENTAL PROTECTION

• Safeguarding the environment must be a
relevant and priority aspect of machine use, of
benefit to the community and the environment
(Translation of the original instructions)